To give you the best possible experience, this site uses cookies. Using your site means your agree to our use of cookies. We have published a new cookies policy, which you should need to find out more about the cookies we use. View Cookies Policy.
Foscam, the world’s most trusted DIY brand sold in over 80 country’s
A off grid Pole Mount Solar kit that includes a PTZ camera with 18x Optical Zoom, 200 Meters Night Vision, Dual band wireless, Auto Tracking and AI detection. This pole-mounted solar power kit uses Lithium battery’s that offer a Run (dark) time of 24 hours with a recovery time from full discharge of less than 30mins at 50% solar power.
Pole mount for solar panel: Aluminium alloy brackets with stainless steel hardware
Setting angle: 45° for capturing the correct angle for the sun
Mounting pole (to be supplied by installer/customer for combination of solar panels and battery/control box): recommended minimum - 75mm x 3mm steel for 3metre above ground
NOTE: POLE is NOT INCLUDED in the kit and dimension are only a guideline. It is the responsibility of the client to ensure that correct erection procedure for the pole is followed.
Wind load: 80Kkm/Hr
Hail loading: 1.1Kn/m ²
Assembled weight (includes 1 x 30W panel): 5kg
Attention: Edges may be sharp
Solar panel mount set comes with: 1 upper bracket, 1 lower bracket, 2 x U-bolts (straps), 2 x M6 hex-head bolts, 4 x washers, 2 x M6 nyloc nuts, 2 x M6 hex-head bolts for solar panel, 4 x flat washers for solar panel, 2 x nyloc nuts for solar panel.
Installation: To the greatest extent possible, the installation site should allow unshaded exposure to the sun throughout daylight hours.
SPECIFICATIONS – Control and Battery Cabinet
Depending upon the customer requirement, two battery pack options are available in the enclosure shown being 16Ah or 24Ah.
Solar charging is by means of a Monocrystalline Solar panel
The solid state controller integrates all aspects required for optimal operation of the unit with:
Solar charge controller specifically for LiFepo4 cells with BMS on 24Ah unit
Regulated outputs for two cameras and a USB communication device
Raw output for a 12V - CPE link
Cabinet: Polyester / Polycarb 300 x 250 x 130mm
Pole mount bracket: U-clamp / strap top and bottom
Batteries: 2 x 12V12Ah LiFeP04 batt pack
Solar Charge Controller: 10A
Camera Voltage Protector: 2A
Connectivity
Supplied two CPE510 pre-configured as a bridge to connect your camera to your main site, line of sight up to 15KM.
Connect the one to the POE injector supplied in the kit and the other at your main site.
Power Connectors for: Camera; Router; Solar panels
Total Weight of control and battery cabinet: 8kg
Cabinet mounting set comes with:
1 upper bracket, 1 lower bracket, 2 x U-bolts (straps),
4 x M6 hex-head bolts, 8 x washers, 4 x M6 nyloc nuts
A off grid Pole Mount Solar kit that includes a PTZ camera with 18x Optical Zoom, 200 Meters Night Vision, Dual band wireless, Auto Tracking and AI detection. This pole-mounted solar power kit uses Lithium battery’s that offer a Run (dark) time of 24 hours with a recovery time from full discharge of less than 30mins at 50% solar power.
Security policy(edit with the Customer Reassurance module)
Delivery policy(edit with the Customer Reassurance module)
Return policy(edit with the Customer Reassurance module)
